In just seven steps this article will guide you on How to Install a Sub woofer in a Factory Stereo. Very often people who are passionate about adding new additional features to their car stereo like sub woofers take the help of audio professionals to do the job. But this job is not at all complicated and can be done without any experience by following simple steps. In this article we shall also discuss the importance of installation of sub woofers, tips and warning for doing this job.

Depth and powerful sound are important for good quality of music. Speakers can be installed at various places inside the car like door panels, dash and rear decks. They enhance the sound effect for higher notes. But to enjoy lower tones adding a sub woofer to a factory stereo is the best choice. Let us see how to do that now.

The negative cable from the car’s battery is removed initially. The battery’s negative terminal is actually connected with the negative cable and to the car’s frame. The cable’s clamp is loosened with the use of a Philips screw driver. The clamp is removed and it is kept aside until the task is accomplished.

Then the amplifier position is located after which the manual is gone through for any kind of procedure to be followed. The woofer can be placed either in the cargo area at the rear back or the car’s trunk in the case of models like hatch backs or SUV. The speakers are then connected to the output corresponding to each input.

The speaker wires are then routed to the location where the sub woofer is present. The amplifiers may be either close by the sub woofer or even far from them. In such cases the wires are routed to the sub woofers through the carpet layer under the floor of the vehicle. Hiding of the wiring is very essential to give your car a highly professional look.

The trim panels at the opening of the door are all pried from the floor free by using a trim panel removal tool. The carpet is then lifted up and the wiring is laid beneath it. Then using the hands the trim panels are replaced.

After that is done we come to the last step. This seventh step is nothing but reconnecting the ground cable with the vehicle battery’s negative terminal. Fix the clamp on the lead and use the same Philip screw driver which we used for loosening now to tighten the clamp of the cable. Before starting to do this job always make sure if the output from the amplifier can be handled by the sub woofer added.

One must definitely know the simple steps on how to install a sub woofer in a factory stereo, to avoid unnecessary visits to the audio professional.

Looking to find the best deal on Auto Hifi, then visit www.powernetshop.at to find the best advice on Car audio for you.

For information on Car Shipping visit MetroGistics.